- Apr 30, 2003
- 80
- 0
- 0
I've finally managed to figure this out.
Specs:
Abit NF7-S rev2
2100+ (t-bred B)
- SK-7 with 80/35mm Vantec Tornado 85 cfm
1GB Corsair TWINX 3200 CL2
Sapphire Radeon 9800 Pro
Default:
266mhz FSB (1.6v)
400mhz mem (2.6v)
mult 13.0
default video
overclocked:
366mhz FSB (1.85v)
366mhz mem (2.6v)
mult 13.0
default video
Sandra recognizes the cpu as an XP 3006+! Yay!
As is, I'm getting 3Dmark2001 scores of 16450. And I have yet to oc the card. I could have gone higher with the FSB but I didn't want to push any more volts through. I was getting temps up to 44C with CPU burn-in. Probably because I screwed up the surface of the heatsink when I tried lapping it. The sandpaper was too coarse and I created deeper scratches. I should take it back off and buy some finer sandpaper to do it right. I'm also using Arctic Silver Ceramique.
I also need to tweak winXP pro to get rid of the junk processes. But not too bad for the first time, eh?
Specs:
Abit NF7-S rev2
2100+ (t-bred B)
- SK-7 with 80/35mm Vantec Tornado 85 cfm
1GB Corsair TWINX 3200 CL2
Sapphire Radeon 9800 Pro
Default:
266mhz FSB (1.6v)
400mhz mem (2.6v)
mult 13.0
default video
overclocked:
366mhz FSB (1.85v)
366mhz mem (2.6v)
mult 13.0
default video
Sandra recognizes the cpu as an XP 3006+! Yay!
As is, I'm getting 3Dmark2001 scores of 16450. And I have yet to oc the card. I could have gone higher with the FSB but I didn't want to push any more volts through. I was getting temps up to 44C with CPU burn-in. Probably because I screwed up the surface of the heatsink when I tried lapping it. The sandpaper was too coarse and I created deeper scratches. I should take it back off and buy some finer sandpaper to do it right. I'm also using Arctic Silver Ceramique.
I also need to tweak winXP pro to get rid of the junk processes. But not too bad for the first time, eh?