• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

My Cube Project 2

Jen

Jen

Elite Member
Decided to build another Cube Case , slightly bigger than my last one. Will feature watercooling


Cube Pictures


dimensions are

14 inchs wide
14 1/2 inchs tall
16 inchs in length


hope everyone enjoys


rose.gif
 
just angle iron and a piece of sheet metal? thats not meant as a put down by any meas it is actually a genuine question. I have been working on something similar to that for a while now, mine is 14x14x14 made out of plexi with the angle iron just holding hte plexi together. I was intending on placing a vericle barrier that ran from front to back to mount the motherboard on one side and the drive cages on the other. I would love as much input as possible, especially from someone who is already making these.
 
Originally posted by: DerwenArtos12
just angle iron and a piece of sheet metal? thats not meant as a put down by any meas it is actually a genuine question. I have been working on something similar to that for a while now, mine is 14x14x14 made out of plexi with the angle iron just holding hte plexi together. I was intending on placing a vericle barrier that ran from front to back to mount the motherboard on one side and the drive cages on the other. I would love as much input as possible, especially from someone who is already making these.
Click to expand...


1/2 x 1/2 x 1/8 angle iron is being used

sheetmetal is pop rivited to the inside of the frame work

a old case donated its slide out motherboard tray which will work out well

i will be makeing custom cages that will bolt in through the front with case thumb screws

this is the second case i have built , first one was similar to your dimensions but i found its to tight to the powersupply so am makeing this one


Jen
 
i decided to move the powersupply over to the side with the drives for both spacing and thermal reasons. I am still not sure if i will mount it at the top or bottom though.
 
Originally posted by: DerwenArtos12
i decided to move the powersupply over to the side with the drives for both spacing and thermal reasons. I am still not sure if i will mount it at the top or bottom though.
Click to expand...

you have my vote for bottom (Lian Li) 🙂
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top