Muwahaha... *more* cruelty to my Lian-Li case! >:)

[mechBgon]

I ported out the filter holder for the intake fans on my PC-86. :evil: Anyone interested can check it out here. The finished filter holder ended up lookin' pretty fine: photo

 

[Cerb]

Nice!

 

[Corporate Thug]

well done

 

[JulesMaximus]

Do you think the safety glasses AND the shield together are a bit of overkill?:beer:

 

[Blooz1]

Good idea, Mech!

I just took mine off, and I've been just using the suction from the fans to hold it on! (But I like your idea much better!)

BTW, how much of that edging did you <U>buy</U> from Frozen? I found the same stuff for sale at McMaster-Carr (McMaster.com) for $.19/ft.! It's on catalog page 3428, "rubber edge trim", shape #12, p/n 8510K11, at $.19/ft for partial roll and $.17/ft for a whole roll.

I've seen the same stuff at mods sites for almost $2 a foot!

 

[mechBgon]

Originally posted by: Blooz1
Good idea, Mech!

I just took mine off, and I've been just using the suction from the fans to hold it on! (But I like your idea much better!)

BTW, how much of that edging did you buy from Frozen? I found the same stuff for sale at McMaster-Carr <a class=ftalternatingbarlinklarge href="http://mcmaster.com" target=blank>(McMaster.com)</A> for $.19/ft.! It's on catalog page 3428, "rubber edge trim", shape #12, p/n 8510K11, at $.19/ft for partial roll and $.17/ft for a whole roll.

I've seen the same stuff at mods sites for almost $2 a foot!

Thanks for the thumbs-ups guys Blooz1, I think I bought four feet of it... I try to listen to the little voice inside that says "buy more than you need or you KNOW you'll end up using it all and having to order again ". Yeah, the markup on some of the items is definitely significant.

JulesMaximus, you're probably right I was using the medium-thickness emery-board cutting wheels, however, and you may know already how shatter-prone those are, especially when cutting slots... a slight catch or kick, and there's pieces of emery board flying all over the place at about 200mph! :Q

 

[cheapgoose]

nice work. if you can, get some diamond coated cuting wheel, haven't hadc one break on me yet, all metal. and if you dont' feel like waiting by your mail box, autozone has those molding for about $3 for like 3 - 4 ft.

oh yea, nice work on the cable sleeving too.

 

[hmsrolst]

Very nice work.

 

[nycdude]

Talk about setting up a how to workshop.

NICE!!!!!

 

[beatle]

Very ! Hey, didn't I see you in UT2k3?

 

[deerslayer]

Great work!

 

[lchyi]

Even cheaper more available edge molding? Take a thick gauged wire (yours to choose from) and slit it down the middle. Rip the innards out and BAM! Rubber C-edged molding. Kick it up another modding notch!