Msi Afterburner

[lavaheadache]

I've been wondering why that when I use the monitoring and OSD utilities for voltage readings it gives me a much different reading than what I selected. In fact they are always higher by a significant margin. For example one card will show 1.25v in the OSD when in fact the cards default voltage is supposed to be at 1.21v

I finally busted out my mulitmeter and used the handy little plugs they give you to test out the card. Low and behold the voltage is actually pretty close to what I selected it to be with the slider.

 

[Rikard]

What does GPU-Z report? It is usually different from AB, and I read that AB (RivaTuner really me thinks) is not doing it completely right. (I cannot remember the link, but it was a discussion at guru3d forum)

 

[lavaheadache]

I didn't realize how bad auto correct botched my OP.