• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Loose LGA 1366 Socket

B

Bearmann

Member
I am disassembling my computer for sale of its parts. It was a custom built (not by me) Gigabyte GA-EX58-UD5 with an Intel i7-920 processor and a Scythe Mugen SCMG-2000 heatsink. While removing the backplate of the cooler, I removed 8 screws, 4 long and 4 short. I'm 90% sure that all these screws were attached to the backplate. (Of course, if they were underneath the backplate there is no way that I could have gotten to them). When I separated the cooler from the MB, the silver CPU socket (CPU holder with the handle) and the CPU stayed attached to the heatsink and not the MB. When I attempted to re-attach the CPU holder to the MB, it is too loose as even the short screws seem to be too long. There are some washers that I removed, but even adding these does not result in a tight attachment. I'm pretty sure that these washers were not used with CPU socket screws anyway as the outer, non CPU backplate holes seem to have some recessed areas around each screw hole for these washers. Adding the thickness of the heatsink backplate appears like it would result in a tight fit, however. I'm assuming that the original short screws which held the CPU bracket had to be removed during installation of the heatsink in order to make the heatsink fit correctly. Do you think this is likely? If so, then the new buyer would have to use the same heatsink or I would need to buy some shorter screws to secure the CPU bracket tightly.
 
Last edited:
I finally found installation instructions for the heatsink and it turns out that I was correct. The original MB backplate was discarded for the Scythe backplate which fasted down the CPU holder as well as the heatsink. In replacing it, I bent some pins however
frown.gif


Oh well.
 
A magnifying glass and a pin or needle should help straighten any pins you bent. It's likely salvageable.
 
Burpo said:
A magnifying glass and a pin or needle should help straighten any pins you bent. It's likely salvageable.
Click to expand...

I don't know. I'm kind of disgusted with the whole thing right now. I spent two days getting it ready, testing with Realbench and Memtest86 screenshots, disassembling, etc. I would hate to sell it and find out its not working and I'm too lazy to put it all back together and test it myself. Interestingly, in my research I found out that when you remove the MB backplate and replace it with the Schthe one, you've voided your motherboard's warranty. It was a nice cooler, but I wouldn't have chosen it had I known it would void the MB warranty.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top