• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Laptop GPU/CPU overheating/fried?

remeca

Junior Member
I have a Dell XPS 1647 laptop, and it has been chugging away flawlessly for the last 6 years or so until today. I was using it when all of a sudden my screen started to glitch out, all kinds of crazy colors and stuff moving all over. It looked like when I used to OC my gpu and I'd hit too high of a clock speed. I turned off the laptop and left it for awhile, and when I turned it back on, everything seemed fine, for about 30 seconds then it started happening again. I took off the bottom of the laptop and turned it on, and discovered that the fan that cools the GPU/CPU wasn't spinning at all. I rigged up a new cooling system using an old laptop cooler (basically just 2 50mm fans blowing 2x their normal speed directly on the heat dissipaters/radiator) , and started up again. I monitored my temps using psensor , and this time it lasted about 2 minutes before it started again, even though the GPU was at 37C and the CPU was in the mid 20s. Anyway, I guess I want to know if you think it's permanently damaged, since the new cooling thing didn't work, is it worth it buying a new oem fan if it still isn't going to work, or is my DIY solution inadequate to properly cool the system? Thanks for any advice/opinions you can give.


Post screen:
PeqMiH7.jpg


Login:
2wDZXzO.jpg


Desktop:
xAZBg1p.jpg
 
Hate to say it, but if temps are showing good, but the artifacting is still happening, then you might have (permanently) fried the GPU.
 
I was worried about that, but the fact that it still works for a little bit on cold boot gives me hope.
 
Before you replace the system board, for a last-ditch effort, just make sure all the connectors to the panel are secure and not being bent/twisted/kinked.
 
Back
Top