kt7 raid/plex in pio/pci bus, what the f#$%!!!!!!

punkkloser

Member
Dec 29, 2000
26
0
0
i got my barebones kit from mwave yesterday.thunderbird 800/kt7 raid/128 mbpc133,added two 20 gig ata 66 maxtor hard drives,soundblaster,tnt 2.ok,sisoft sandra says my pci bus is running at 50mhz,and it is set to 33 on softmenu(100/33)?????????????????????????????????. the two maxtors are hooked up to 3&4,and my plex 8432 is ide 1,toshiba 6702 is ide 2.the initial screen says my plex is in pio??????.ive tried everything to change to dma,tosh is in dma??? ive read the kt7 faq and i think i'm doing this right.all drives are set to master.am i doing something wrong with the setup
 

okydoky

Senior member
May 10, 2000
387
0
0
Most burners run in pio mode. Couldn't give you a good take on your fsb though...
 

jimmygates

Platinum Member
Sep 4, 2000
2,134
2
81
Um..it was well documented that Sandra had problems reporting the PCI speed with KT133 boards.




-Jimbo