KR7A PROBLEMS

[xs8r]

i just got the kr7a board with a XP 1900+, i was a pain in the ass

i couldnt get my 98SE loaded on it, so i had to take my HDD out and put it in my other pc and load 98SE then upgrade to XP, then put it back in my new case with my board, now i its seeing it as a 1200mhz when its suppose to be 1600mhz

ive tried everything in the bios, when it starts up and sees it as a 1600mhz XP it doesnt load the OS, but if i select fail-safe defaults, and 1200mhz, its wors, whats going on, somethings is messed up horribly bad, please help, ill give the details u need...

anyone, please...

 

[xs8r]

motherboard: kr7a
cpu: xp1900+
vidcard: radeon 8500 64mb

i think thie bios is messed up, when i changed the cpu settings to "1900+", it wont start up, =[

whats going on =[

 

[o1die]

Enable cmos jumper for 10 seconds (with system off) then return jumper to original position. Re-boot and adjust fsb to 133 in bios. This may help.

 

[Kubota]

Clear cmos and try again. Mine does that and i'm trying to figure it out too. I have a 1600+ and it recognizes it as a 1050mhz. When i change to 1600+ in bios it will shutdown the first time and will power up for like 2 sec and then off again. I can clear cmos and go set bios to 1600 again and it will reboot fine. I have another problem that when I shut down the computer and leave it for 10 minutes or more it will not power up ( no light, fan) nothing. I will however power up if i hit the buttong right after shut down.
?????????????????????

 

[NuovoTech]

You sure your RAM is seated properly?