Just looking for a once over on this system...

thereelaristotle

Junior Member
Feb 13, 2009
5
0
0
Just wanted to check I didn't have any glaring mistakes here, its been a couple years since I upgraded, thanks.

FYI running two 24 inch screens.

Mobo: ASUS P6T Deluxe V2 LGA 1366 Intel X58 ATX Intel Motherboard

CPU: Intel Core i7-920 Bloomfield 2.66GHz LGA 1366 130W Quad-Core Processor

RAM: CORSAIR XMS3 6GB (3 x 2GB) 240-Pin DDR3 SDRAM DDR3 1600 (PC3 12800)

HDD-: Seagate Barracuda 7200.12 ST31000528AS 1TB 7200 RPM SATA 3.0Gb/s

VC: (2x CF) XFX HD-585A-ZNFC Radeon HD 5850 (Cypress Pro) 1GB

PSU: CORSAIR CMPSU-850HX 850W ATX12V 2.3


Case and peripherals are taken care of. Thanks again.
 

MalVeauX

Senior member
Dec 19, 2008
653
176
116
Heya,

Nope. Looks solid. Except that the P6T has a lot of track record of being a finicky board.

Going to overclock it, or run stock?

Very best,
 

yh125d

Diamond Member
Dec 23, 2006
6,886
0
76
PSU way overkill unless you're planning massive OC + xfire in the near future
 

Ayah

Platinum Member
Jan 1, 2006
2,512
1
81
Looks pretty good imo. You probably want some aftermarket CPU cooling though.
 

thereelaristotle

Junior Member
Feb 13, 2009
5
0
0
Heya,

Nope. Looks solid. Except that the P6T has a lot of track record of being a finicky board.

Going to overclock it, or run stock?

Very best,


Usually I'll do a little OC'ing when I'm first setting up and then just leave it, I don't constantly tweak or drive myself nuts over a few mhz. For example I've had my last PC, with an E6300 at 3.2GHZ for it's whole life.

If you think there is a better board, I'll check it out.
 

alyarb

Platinum Member
Jan 25, 2009
2,425
0
76
i'd probably get a samsung hard drive. seagate's reputation for reliability, at least with large disks, has dwindled hopelessly. i even took a chance with a WD20EADS that bricked on me, and I used to like WD. hitachi deskstar and samsung F3 are faster/cheaper than seagate with vastly lower probability of failure. i'm pretty much in bed with samsung for the time being, never had a dead drive from them, and finding a big drive without any issues (especially the way newegg ships them) is easier said than done. just get the 500GB platters (spinpoint F3) for speed/efficiency. the F3's are a little more difficult to find than the F1's.
 
Last edited:

MisterDonut

Senior member
Dec 8, 2009
920
0
0
Samsung or a WD caviar black. One of my friends has had both, and he likes the WD better (Pitted his old Samsung against a Raptor and held his own). I would get a cheap aftermarket cooler for a minor overclock or spend a little more for the higher end ones. A cooler chip is always better ! I would personally overclock an i7 just cause it has the potential, otherwise I would have picked up the i5 for the turbo mode...but that's just me :).
 

thereelaristotle

Junior Member
Feb 13, 2009
5
0
0
Samsung or a WD caviar black. One of my friends has had both, and he likes the WD better (Pitted his old Samsung against a Raptor and held his own). I would get a cheap aftermarket cooler for a minor overclock or spend a little more for the higher end ones. A cooler chip is always better ! I would personally overclock an i7 just cause it has the potential, otherwise I would have picked up the i5 for the turbo mode...but that's just me :).

Will check out the Samsung drives, I've always been a fan of most of their other electronics, I may as well.

Also was going to grab this cooler: ARCTIC COOLING Freezer 7 Pro Rev.2 92mm Fluid Dynamic CPU Cooler.

Looks a little easier to work with than the Tuniq tower I had on my old CPU, which while great operationally was flat out unwieldy to work around at times.
 

theyedi

Member
Dec 27, 2009
32
0
0
What do you mean by the P6T being a finicky board? I'm curious because I plan on getting it with an i7 920 with plans to OC to around 4.2 ghz.
 

MisterDonut

Senior member
Dec 8, 2009
920
0
0
Nothing wrong with the P6T AFAIK. My friend has had it for a solid 6 months now (V2 Deluxe) and hasn't had any issues whatsoever. Has his i7 OC'ed to ~4ghz.