I keep geting this error message!

Backup

Junior Member
Aug 15, 2005
22
0
0
I get this whenever I try autoruning something from my cd drive:The procedure entry point 'this name depends on the cd' could not be located in the dyanamic link library KERNEL32.ddl. This started happening when I replaced my motherboard with the exact same model.This message doesnt come in safe mode without networking but some programs cant install because the screen resolutions too low.I tryed reformating,running sfc /scannow and repairing windows.I have windows xp home edition.Could there be any 3rd party programs that can fix this?
 

MobiusPizza

Platinum Member
Apr 23, 2004
2,001
0
0
Try another CD drive?
Try plugging CD drive in another IDE channel?
Check for IRQ conflicts?
Check motherboard BIOS settings.
 

wpshooter

Golden Member
Mar 9, 2004
1,662
5
81
Originally posted by: AnnihilatorX
Try another CD drive?
Try plugging CD drive in another IDE channel?
Check for IRQ conflicts?
Check motherboard BIOS settings.

I would do the last one listed FIRST, make sure every BIOS setting is exactly as it was with the old motherboard.

Then one question, why did you change motherboards. Did the old one have some defect ? If it didn't, why would you change to the exact same board ?

 

Backup

Junior Member
Aug 15, 2005
22
0
0
I changed my motherboard because when I tryed pachting the bios the motherboard didnt turn on again. With the same one because my restore cds only work with the same one.The cd drive used to work before I replaced my motherboard and does work but only in safe mode.