HOWTO: Minimizing Vcores and Operating Temps-MUST READ

Page 2 - Seeking answers? Join the AnandTech community: where nearly half-a-million members share solutions and discuss the latest tech.

bryanW1995

Lifer
May 22, 2007
11,144
32
91
ok, when I was overclocking my x3350 a few weeks ago I didn't have it checked and prime 95 would continue running, so I know that it's not a fluke for you idc. I would get a red box on the core that had failed and a message on that thread but prime did NOT stop. I miss orthos...it has pretty graphics...;)
 

bryanW1995

Lifer
May 22, 2007
11,144
32
91
Originally posted by: Drsignguy
Originally posted by: bryanW1995
Originally posted by: Drsignguy
Sounds to me that we need a "cross" referance chart for each manufacturers bios.

what are you voltages as listed in bios? then we need an asus and a few of the little guys like biostar, msi, etc and we should be gtg.


As per your request sir. Here are a couple of snapshots of the MIT tweaker from the GA-EP35C-DS3R rev 2.1.

1st half
2nd half

J


ok, ddr2/ddr3 overvoltage and cpu voltage are both obvious. mch is obvious to an abit user. what about pci-e and fsb? I assume that one of those corresponds to cpu vtt, but which one? or are those two the ichio and ich, with cpu vtt hidden somewhere else???
 

Robster

Member
Jul 16, 2005
126
0
0
Very nice howto guide graysky

Now I feel like i wanna start over from the beginning, and just do everything starting from low voltages and one step at a time. It is the most wise procedure and less variables are produced.
 

Drsignguy

Platinum Member
Mar 24, 2002
2,264
0
76





Originally posted by: bryanW1995
Originally posted by: Drsignguy
Originally posted by: bryanW1995
Originally posted by: Drsignguy
Sounds to me that we need a "cross" referance chart for each manufacturers bios.

what are you voltages as listed in bios? then we need an asus and a few of the little guys like biostar, msi, etc and we should be gtg.


As per your request sir. Here are a couple of snapshots of the MIT tweaker from the GA-EP35C-DS3R rev 2.1.

1st half
2nd half

J


ok, ddr2/ddr3 overvoltage and cpu voltage are both obvious. mch is obvious to an abit user. what about pci-e and fsb? I assume that one of those corresponds to cpu vtt, but which one? or are those two the ichio and ich, with cpu vtt hidden somewhere else???
















This was my question when I took the snapshots. I really dont have a clue which one it is or if either of the 2 are? I will double check and check my maunal.