How do I install the OS on a SATA drive when using NF7-S v2.0?

[BBCMember]

Also, I just installed the SATA drive and set the bootup sequence in the BIOS to FLOPPY, CD-ROM, SATA. However, when I boot up from the Windows CD, it only shows the IDE drives. Do I disconnect them when installing the OS on the SATA drive? If not, how do I have the system see the SATA drive?

I have an ABIT NF7-S v2.0 mobo, and under "Onboard PCI Device", I have both the SATA ATA Controller and the SATA RAID ROM enabled. Should I disable the SATA RAID ROM?

Should I change any of the settings for the IDE controllers in the BIOS?

 

[BBCMember]

Never mind. Had to install the SATA drivers.

 

[i1135t]

Too bad it doesn't work with Vista... I've tried already