• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Hooking up a volcano 7+ to p41.6a

H

Haunter9X

Member
Okay, I finally got my new chip and everything. On the volcano 7+ heatsink, there are a plethora of cables coming off of the fan. There is a white three pin connecter coming off a yellow cable from the fan, then there's a red three pin coming off the three to four converter, and then there's the four pin connecter with two wires in it. Which of these wires goes where? I think the white one goes to the mother board and the four pin to the power supply and the red one gets ignored. Does this sound right?
-Haunter9x
 
I have the motherboard plug with the white connection with the yellow wire (the one that branches off immediately from the fan) plugged in. I also have the fan speed toggle switch plugged in and it works fine, so I'm not sure what the red connection is used for.
 
I don't remember my own wiring, it's at home....

the thermalright website for the volcano 7+ shows the setup of the wires, I did mine looking at the site...

 
did you guys try removing it so i can re-seat, i tried removing that sob and broke one of my retention clips 🙁
still works good with one broken...sigh
i plugged the white connector to the motherboard header and the 12v and left the brown connector unplugs, still works perfectly fine for me
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top