• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Help with Dlink DFE-910

T

Thira

Member
I had to reformat my hdd. I am having problems etting my network working again. The client is fine. It is the server that I cannot seem to setup properly.
The drivers for the card are ok. I singled ckicked on Network Neighborhood, right ckicked, properties, then highlighted tcp/ip to the DFE 530+, went to properties. I specified the proper IP address, disabled Wins conf, & left the gateway blank. Closing out & rebooting, double clicking on Network Neighborhood, , F% multiple times , only shows the server on the network. Pinging the client Times out.
What did I leave out?
Any suggestions as to how to get the network going again?
Thanks
 
Ummmm....

-> double check the ip number

-> check the net mask

-> check the hardware (cables, hub, etc., switch it all out with known good ones)

-> triple check the ip

You are pinging from a dos prompt right? If that doesn't work, it's probably a pretty low level failure.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top