Help with celeronII 533 O/C to 896, components... also, how do i change voltage of AGP?

[BlazingSaddles]

I have my celeron overclocked to 896, and I've ran Stability test for 11 hours+. also my computer has been on for almost two days, so I think the chip is stable. However, when I run 3dMark2000 1.1, it freezes up my computer. does this have to do with the video card, rather than the CPU?

I'm running with a MSI 6905Dual(?) slocket, golden orb, Asus P2b-f MB. I have a PCI Voodoo2 and an AGP Savage4. Which one could be the problem. Also, I only have PC100 RAM O/C'ed to 112Mhz.

 

[BlazingSaddles]

^

 

[Hyperchronismos]

At 112MHz FSB your AGP bus speed is at 112*2/3=75MHz instead of 66MHz.Maybe this is the problem.Try to change the +3.3 Voltage to 3.5 Volts.It is the same as increasing the CPU voltage to stabilize it.

 

[riceboi5]

With my 533 @ 896 @ 1.6 its very stable. I'm using a V3 2000 AGP @ 160. Most likely it's your Savage 4 that's the problem....

 

[BlazingSaddles]

Hyperchronismos, how do i change +3.3 to 3.5?

 

[Viper GTS]

Change the I/O voltage, if your board supports it.

Viper GTS

 

[Eug]

Aren't you running 3.5 V anyway with that board? I believe the more recent versions at least ship at VIO 3.5 V.

You can check by looking in the power management section of the BIOS at bootup.

 

[BlazingSaddles]

Yeah, i just checked the power management settings and I am running at 3.5. Any other problems you see? Does the Ram being O/c'ed have anything to do with anything? pc100 overclocked to 112, but i've seen lots of people say 112 is ok with quality pc100

 

[Eug]

Try a Cas 3 memory setting to rule out your memory.