HELP...SETI@home CLI setup/configuration questions

[Sunny129]

see post below for questions...

 

[Sunny129]

i have a question about Smokeball's installation instructions for SETI@home CLI v3.03...it doesn't really say anything about the SETI Client Priority box in the SETI Driver window. i have mine set to low just b/c i think that's what it defaulted to when i first installed it. does anyone else use the "normal" or "high" setting? should i be using a different setting? thanks, Eric.

oh yeah, one more question. if i leave the "display transmit" box checked, what exactly will it display? will the DOS window pop up again and show me the DL of a new WU once the current WU is finished?

EDIT...one more question. i'm using SetiSpy to monitor my progress. there is a "use SETI Spy" check box at the bottm of the SETI Driver window that Smokeball said to leave unchecked at his installation/ setup instructions webpage. SETI Spy seems to be monitoring my CLI's progress fine with the box unchecked. is there a reason it needs to be checked off? i would assume it only needs to be when one is using SETI Spy, but my SETI Spy seems to be working w/out the box checked. should i then leave the box unchecked or what?

 

[soni]

Leave priority at low, no need for it to be higher..

If display transmit, then yes, setidriver will show dos command window when transmitting, no need either..

The setispy i think is so that seti driver waits a few seconds between uploading the finished units.
Basically it allows setispy to discover that the unit have finished.
Recomendably for users of setispy..