Help configuring my system

[Modeps]

Hey, I've got a Barton 3000+ and an Epox 8K5A2+ mobo with 1gb of 2700. For some reason, my settings have it running at 1733mhz instead of what it's supposed to be running at. I'm a bit confused as to what I have to do in the bios though to get it up to (2167mhz).

Can someone give me a hand? I feel stupid because I didnt notice it was set like this before, so I've been effectively running my Barton as a Athlon 2100+.

TIA

 

[Kogan]

It sounds like you have your front side bus (FSB) set to 133mhz when it should be 166mhz.

 

[Modeps]

You're correct sir, it is set to 133. However, I dont see a way to change that manually, all it says it FSB: 133 in the bios.

Here's what I've got:
System Performance: Normal (other choices: Fast Fastest Turbo)
FSB: 133mhz (not changable)
DRAM: 166mhz (not changable)
DRAM Clock: By SPD (other: 133, 166)
Dram Timing: By SPD (other: manual)

Not sure what any of the other features are... the BIOS has never been my strong point.

 

[Modeps]

Ok, those settings are actually underneath the DRAM settings, so I dont think that's where I need to mess around. The only spot I can see where I can change a multiplier at all is under frequency/voltage settings, and if I change the CPU clock there from 133 to 166 and the multiplier from auto to 13, it will reboot and always set things back to 133/auto... ugh.