• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

HDD temps?

Charlie98

Diamond Member
I was reformatting a 80GB WD (WD800JD) in my old Dell and the temp of the drive got to 141F...

Acronis Drive Monitor threw up a warning saying it was beyond the 125F normal/safe temp.

How high can an average HDD go before it is damaged?
 
Speak Celcius . Your hard drive should be under 35c to 40c for a very long life span.
 
Last edited:
My old IBM 75GXP lost a few sectors when using it when temps got above 55C.

Edit: It was enclosed in one of those IDE mobile rack contraptions. Without a fan.
 
Last edited:
Wow I didn't know temps matter whether a sector stays alive or dies....55c is extremely high.. 40 is doable ,, but 35c recommended.. perhaps open your side of case , let us know. gl
 
The common maximum operating temperature specification of 55C or 60C (131F or 140F) is based on the temperature of the air surrounding the disk drive, not that of the drive itself, meaning the drive can run hotter without harm. Google found that its disk drives failed least often over a temperature range of 38C - 46C, rather than at 25C.

7200 RPM 3.5" hard disks typically reach 45C - 50C inside desktops, unless packed with very little air space around them, but the minimum clearance specification is just 0.5mm.
 
Specifications are fantastic when you have a dead drive sitting on your desktop due to heat. What then? "But the spec said...!!"

Protip: Just put a fan on that bitch.
 
.. perhaps open your side of case

Actually, I had the side of the case off. I installed a newer processor that failed to boot, so I reinstalled the slow dinosaur Pent D and had the cover off while I was reformatting the drive (for a clean install of Win XP.)

If this keeps up, I'll punch some holes in the side of the case and put a fan in there...
 
You should get Thermaltake iCage ,,,, takes up 3 bays ,,, blue light 120mm fan 3 hard drives you can put in the cage...... gl
 
Google's paper showed increased failure rates at both too hot and too cold. I can't find the PDF ATM, but IIRC, there was negligible difference in failure rates until 60C+.
 
Google's paper showed increased failure rates at both too hot and too cold. I can't find the PDF ATM, but IIRC, there was negligible difference in failure rates until 60C+.

diskfailuresvstemperatu.jpg
 
Last edited:
Back
Top