• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Hard Drives~how to configure???

T

triska

Platinum Member
i have two hard drives
one is ata66 connected to my mobo
and hte other will be a at100 connected trhu a pci card
now, the ata66 is 20 gb and i want to connect the 80 gb to my comp
but it sez that it is teh master and that the slave is off
as well as on the 20 gb that is running rite now
wut do i do?
can i make one a slave and how?
wut should i do?
im oblivious in hd's
thanks for the help
email me or pm
phantazn8@hotmail.com
 
since it's connected to two different IDE controller.
Both of them can be a master.

Anyway if you still want to make one of them slave, you can change the jumper in the HD.
it's in manual or the sticker on top of the HD usually have a drawing of jumper setup.
 
they're both on different controllers, right? One's on the mobo controller and one's on a separate pci controller? Set 'em both to master and you're fine.
 
so i gotta install my OSback on them?
and how would i do it?
like im gonna get my card tomorow im presuming, so i jus plug it in, and install windows on it or sumthin?
well thanks for hteadvice
appreciate it!
 
if they are on seperate controllers (one MB, one PCI card) both should be set to "master", make sure the jumpers are set correctly on the back of the drive,
(plastic sqaure things) If you don't already have an OS on your computer, then you'll have to install one
 
No, you only need to have your OS installed on one of your two drives (both set as master) Because only one of these drives is bootable.
Are both of these drives installed in your PC? The best way to configure your Hard Drives, If your PCI IDE controller (hopefully ATA100)card has Two channels on it, attach to channel One, your ATA100 (hopefully 7200rpm) set as Master, using one of your two ATA100 IDE cables. Attach your ATA66 (most likley 5400rpm) set as Master to channel two, on the controller card.
Your Fastest Drive should be bootable, and the bootable drive is where you OS should be installed. Use FDISK to. best thing to do now is to go to PC Guide www.pcguide.com lots of information there to preparing HD.

Hope this helps
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top