Guys what is the default settings of this 2600+ mobile?

[jediphx]

http://www.newegg.com/app/ViewProductDesc.asp?description=19-103-436&depa=0)http://www.newegg.com/app/ViewProductDesc.asp?description=19-103-436&depa=0


I thought it would be 15x133 but when I try that it says cpu is unworkable please reenter bios

 

[jagec]

you're currently running it at 200x12.5 and you're worried about it not running at stock?

 

[influenza]

Gis sig says 2500 and the topic 2600, maybe that's what causing the confusion? On my board the multiplier for this processor cannot be higher then 12,5. So that could be the cause of the problem in this case too. Try 12,5 X133.

 

[influenza]

Gis sig says 2500 and the topic 2600, maybe that's what causing the confusion? On my board the multiplier for this processor cannot be higher then 12,5. So that could be the cause of the problem in this case too. Try 12,5 X133.

 

[DaNorthface]

he has a NF7-S v2.0, the motherboard should handle the high multipliers..

 

[jediphx]

I flashed to the d22 a1bkr2 bios by TicTac and now all my multiplier problems are gone and the chip boots fine at its default 15x133 (with d23 bios for some reason it would say cpu was unworkable) Maybe all my problems were from a bad bios flash when i first setup the system I think I had the processor overclocked at the time and must not have changed it. 200x12.5 runs fine, UT2004 and 3dmark very stable however prime crashes after about 2 hours. Is it really that important that prime not crash if everything else is working fine?