Guide on O'c my XP 2400

[baloy]

Ok, tried o'c up to 166 and my mobo wont boot. So i started a little like Im supposed to. Right now im at FSB 140 and i left my multiplier at 13. When i open WCPUID, it says that my multi is at 15. Weird. Well, ran Prime95 for like 12 hours and no errors. So i guess, im ok. Question is when do i worry about like my pci/agp settings. I left it at default of 4-2-1. ( i think ) What else do i change. Did notice a bit of improvement from 2.0 G to 2105.78 mhz.

Any thing else i have to look for? When do i inc my voltage?

 

[baloy]

Anybody?

 

[pspada]

4:2:1 may be your entire problem. The 1 is the PCI bus, 33Mhz; the 2 is the AGP bus, 66Mhz. So, 4 would be the FSB speed, 133Mhz. If you want to run properly at 166 FSB, that would be 5:2:1. Then if you still have problems you can exclude the PCI and AGP buses from consideration.