After it was fully charged, I decided to test it out on a few devices. First up was my iPhone. There are two different power output options on the device. One runs at 2.0A and the other at 5.1A. I decided to use the 5.1A and plugged in my iPhone. It charged my iPhone from 35% to 100% in 1h 35 m, which is what I expected. I have to admit that I was using the phone some during that time as well, so I'm sure the results were a little skewed. After charging, the device showed 50% power remaining. Not to shabby if you ask me.
Next it was on to the iPad. I charged the FREMO all the way again and plugged in the iPad. Once again using the 5.1A output. This time the charging was much slower. It took 45 minutes to put a 12% charge on the iPad. I left it go for another 2 hours which got me a 41% charge. The FREMO showed that there was only one LED of power left, so about 25%.
Facebook
Twitter