epox 8k3a (kt333) work with future cpus (barton)?

[joey2k]

I noticed the bios of this mb (epox 8k3a, KT333) allows adjustment of the FSB to 200, maybe higher. Let's say the barton comes out and runs on a 200 MHz FSB. Is there a possibilty that I could buy the new CPU, some faster ram (400 MHz ddr) and away I go (assuming MB supports voltage, epox produces bios, etc)? Or with the KT400 or equivalent chipset be required? What would be the deciding factors?

It would be Sweet if it was possible!!! Or, if not, I guess I'd just have to get a hammer .

Thanks
-- Joel

 

[joey2k]

bump

 

[Heinrich]

I don't think that the answer is out there yet. Maybe.