ECS K75tsa Bios Flash Failure (Help)

[Viper300]

Okay I flashed the new bios for my board with lan. Everything seemed fined flash went thru without a hitch. After flash it rebooted itself and nothing but blank screen. It is trying to access the floppy but no video. I tried putting the bios on floppy and booting after renaming to AMIBOOT.ROM and it starts reading the floppy and light stays on but nothing. Anyone have any ideas on what to do. My dealer will not replace due to flash failure. Any help on fixing this will be very much appreciated

 

[ignorus]

I read an amptron (owned by PCChips) .pdf thing on flash failure earlier today, and it said something like it would take 3-4 minutes and then beep 4 times when done.

[edit]
I found it here -> http://www.amptron.com/documents/Recover.pdf

"RECOVERING A CORRUPT AMI BOOTBLOCK BIOS
[snip]
NOTE: Make sure that the PC speaker inside your computer is working before you proceed.
When the BIOS has been restored your system will beep four times to let you know.
To restore an AMI BootBlock BIOS follow these steps:
1) Format a good working 1.44MB floppy diskette.
2) Copy a working BIOS ROM file for your motherboard onto the floppy disk. BIOS ROM
files can usually be downloaded from the motherboard manufacturer?s web site. If you
cannot locate a BIOS ROM file for your motherboard then call the motherboard
manufacturer for technical support.
3) Rename the BIOS ROM file ?AMIBOOT.ROM?
4) Turn the system on and insert the disk into drive A:
5) After about 3 ~ 4 minutes the system will beep four times. Remove the disk from the
drive. The computer will then restart.
At this point your BIOS should be restored and the system should startup normally..."