I have an AYHJA 1333 on an ABIT KT133A running at 1500 (150*10 stock voltage), my case temp is curently reported by MBM 5 to be 82 F with an idle temp of 84 F and a full load temp of aprox 111F
This is with a Volcano 7 and artic silver, there is also a blow hole in the side of the case with a duct blowing air directly onto the Volcano 7.
My friend says my temps are totally unrealistic and that my probe must be off or not making contact with the cpu... I tried to bend it up so that it was just touching the cpu last time I reseated the CPU..
so what do you guys think? am I way off or is his setup just sucky? (130F temps)
This is with a Volcano 7 and artic silver, there is also a blow hole in the side of the case with a duct blowing air directly onto the Volcano 7.
My friend says my temps are totally unrealistic and that my probe must be off or not making contact with the cpu... I tried to bend it up so that it was just touching the cpu last time I reseated the CPU..
so what do you guys think? am I way off or is his setup just sucky? (130F temps)