- May 29, 2015
- 475
- 155
- 116
Today I added a temperature sensor to my system. It was powered by the 4 pin molex strait from the PSU. The pass-through went to a case fan. The system ran fine for maybe 15 seconds then shut down. Now it wont start. The motherboard LEDs work and the USB keyboard light up. I swapped the PSU and the results were the same. I put a motherboard bypass plug on the PSU and the PSU fan and water pump started running.
I'm running out of things to test and I'm guessing the problem is the motherboard. I'm not sure how the sensor could have shorted the MB when it was only connected to the PSU molex but I suppose it's possible. The Motherboard is a ASROCK X370 Killer SLI/ac with 2600X.
If I need to replace the motherboard I can get a MSI B450 Tomahawk tomorrow.
I'm running out of things to test and I'm guessing the problem is the motherboard. I'm not sure how the sensor could have shorted the MB when it was only connected to the PSU molex but I suppose it's possible. The Motherboard is a ASROCK X370 Killer SLI/ac with 2600X.
If I need to replace the motherboard I can get a MSI B450 Tomahawk tomorrow.