DFI lanparty UT3 250gb NOT TURNING ON

[k0rnh0li0]

so yesterday everything was working fine used a 400 psu to turn it on so forth.

swapped out psu for a 500 watt psu ran it for 3-4 hrs then BOOM crash. now only 1 led is on instead of two. one located under pci slot and one located next to the ram.

obviously i tried the battery and reset on board for several minutes but the ram led light wont come up

specs:

dfi lan party ut3 250gb
1gb 512x2 pqi ram
7800gs oc 256mb agp
1 pci card
1 sata
2 ide
2 opticals.

used calc and it suggested 400 watts. 500 watts and it still wont turn on.

Moved from Mobo to Comp Help at member's request- Mobo Mod DAPUNISHER

 

[k0rnh0li0]

i think this needs to be moved to computer help. sorry wrong section of the forum

 

[ExcaliburMM]

I really hope it isn't the mobo. I swear by DFI boards, love them so much.

 

[Heidfirst]

nm

 

[DAPUNISHER]

I will move this to the forum you requested, and I have some questions too.

Did you try each stick of ram, 1 at a time? Try the 400w PSU again? You can pull it from the case and try booting barebones too. I'd even use a screwdriver on the power button pins to start it, just because.