CUSL2-C Problems

ssWhiplash

Junior Member
Jan 18, 2001
3
0
0
I just installed an ASUS CUSL2-C MB and a P3-800eb. Upon boot I get absolutely nothing! No beeps, no video, nothing. The fans do come on and the led on the MB comes on so I know there's power there. Here's what I've done so far:
Pulled the RAM. Computer gives one long beep then nothing. Still no video.

Pulled the CPU. Computer gives car alarm beeps, hi-low-hi-low, etc. No Video.

Swapped power supply. Same problems.

So I think it's obvious I have a bad something but ASUS doesn't talk about any of the beeps I'm getting. So my question is, should I send back the MB or the CPU first?

Thanks

Dana

 

maxSe

Golden Member
Aug 23, 2000
1,947
0
0
You've probably done this already, but try pulling out the vid card & reinsert it (a bit firmly) and make sure the card is all the way in...
 

ssWhiplash

Junior Member
Jan 18, 2001
3
0
0
Yep, done that. In fact, I've swapped vid-cards out and even run the board without a card, trying to get a series of beeps that makes sense. But I haven't been able to get anything but that one long beep, then silence. I think I'm going to swap the MB first, but I'm wondering if this could be a CPU problem?

Dana
 

ssWhiplash

Junior Member
Jan 18, 2001
3
0
0
Well, turned out that the MB didn't like my other RAM chip. Got a new one and BAM, the sucker started right up. Wierd.

Dana