CUSL2 Bois flash from 1001a to 1002-Floppy Drive fail (40)

[Noid]

Well, Everything was running fine until I wanted to fix the temperature problem in the Bios 1001a.

I flashed to 1002 and get this message after primary and
secondary devices are detected.

Floppy Drive fail (40)

What's it mean ???
I flashed back to 1001a ... and I still have this problem.

The floppy drive light is on all the time, and WIN98 wont
read the disks.

 

[Zipperhead]

How did you flash back 1001 if your floppy drive did not work?
Anyway that usually means either the ribbon cable is plugged in
incorrectly or in your bios you need set a few things.

fdc controller:enabled
enable floppy in the boot sequence,1st or 2nd
floppy search:enabled

Try this,good luck


Zip