Corsair Vengeance feedback wanted

[dkm777]

Greetings,

I would like to ask all Vengeance owners - did you have any trouble with your RAM? So far I've dealt with two kits (one dual- one triple-channel) and they were nothing but trouble. The dual kit refused to work at 1.5V but since I used it in an X48 board I just cranked the voltage to 1.65V and called it a day. On the triple-channel kit I had one stick fail and the replacement ran unstable. I RMA'd it again but I'm not getting my hopes up. The old XMS3 RAM I used before was great. Maybe I just have bad luck?

 

[Puppies04]

Mine hasn't had any major problems, it didn't like running at 1866mhz until I tweaked bios setting a little but other than that I was quite happy.

 

[velis]

I deployed two configurations using this memory without any problems whatsoever. Used 1.5V in both instances.

 

[ronbo613]

No problems with mine at 1600 @ 1.5v

 

[MontyAC]

No problem with a Z68 board and 4 sticks. Running at XMP mode with 1.5 volts.

 

[Kenmitch]

No issues with my 8gb kit in my sig system. Runs fine at stated specs.

 

[GrumpyMan]

No issues on mine, all four slots populated run it at 1600 1.5v, love it.

 

[suklee]

No issues, 2x4gb sticks at 1600 1.5v.

 

[Capt Caveman]

No problem with a Z68 board and 4 sticks. Running at XMP mode with 1.5 volts.

Same here.

 

[Panopticon]

I just bought the 4x4gb kit from newegg looking forward to getting my new put together. I used an 8gb vengeance kit in a build this past year and as far as I know the owner has not had any problems with it. I have read around a bit and found that sometimes to get this kit to run at 1600 you manually have to adjust the voltage and timings in your bios which is no biggie.