hey guys,
Might have seen my other two posts about video settings and CPU settings. Just double checking everything since I have never worked with a motherboard this advanced. It ran fine with the "auto detected" or Default settings whatever it was at but I made some adjustments and it seemed to work fine also. Couldn't tell much difference. If these are wrong please correct me. I'm just looking for the correct/optimal "stock" settings.
-With Abit AV8, FX-55, 1GB OCZ Plat Rev.2 DDR400:
DDR DUAL CHANNEL 128 Bit
Manual Configuration
FSB- 200mhz
DRAM- 200mhz
DRAM clock- DDR400
DRAM command rate- 1T
CAS latency time- 2.5
RAS# to CAS# delay- 2 clocks
Minimum RAS# acive tme- 5 clocks
RAS# precharge time- 2 clocks
Row cycle time- 11 clocks
Row refresh cycle time- 14 clocks
RAS# to RAS# delay- 2 clocks
Write recovery time- 2 clocks
Write to read delay- 2 clocks
Read to write delay- 5
Please let me know. I think this ram is 2-2-2-5 so I didn' tknow if the last settings were I set that or not.
Thanks for your help...
Rhin0
Might have seen my other two posts about video settings and CPU settings. Just double checking everything since I have never worked with a motherboard this advanced. It ran fine with the "auto detected" or Default settings whatever it was at but I made some adjustments and it seemed to work fine also. Couldn't tell much difference. If these are wrong please correct me. I'm just looking for the correct/optimal "stock" settings.
-With Abit AV8, FX-55, 1GB OCZ Plat Rev.2 DDR400:
DDR DUAL CHANNEL 128 Bit
Manual Configuration
FSB- 200mhz
DRAM- 200mhz
DRAM clock- DDR400
DRAM command rate- 1T
CAS latency time- 2.5
RAS# to CAS# delay- 2 clocks
Minimum RAS# acive tme- 5 clocks
RAS# precharge time- 2 clocks
Row cycle time- 11 clocks
Row refresh cycle time- 14 clocks
RAS# to RAS# delay- 2 clocks
Write recovery time- 2 clocks
Write to read delay- 2 clocks
Read to write delay- 5
Please let me know. I think this ram is 2-2-2-5 so I didn' tknow if the last settings were I set that or not.
Thanks for your help...
Rhin0
