So about two weeks ago my CEL comes on. I swing by Autozone and the code comes back saying the engine temp is below the coolant temp (or vice versa). We check the coolant level and it's really low, 180k miles, never had a change/flush/top off.
I decide to do a coolant flush myself and everything seems to be working great for a week, until my CEL comes on again. I pull over and see my radiator drain plug was falling out and it drained about half the coolant. I fill it back up and make sure it's all secured, fine for another week.
This morning, first colder day in FL this year (45-50 degrees), my CEL comes on a few miles into my drive to work. I pull over and my coolant is full, no drainage at all. I speed back up and notice my engine temp is dropping the faster I go, when I slow down for traffic, the engine temp rises.
Any ideas? Seems to be the opposite of what engine temp should be.
I decide to do a coolant flush myself and everything seems to be working great for a week, until my CEL comes on again. I pull over and see my radiator drain plug was falling out and it drained about half the coolant. I fill it back up and make sure it's all secured, fine for another week.
This morning, first colder day in FL this year (45-50 degrees), my CEL comes on a few miles into my drive to work. I pull over and my coolant is full, no drainage at all. I speed back up and notice my engine temp is dropping the faster I go, when I slow down for traffic, the engine temp rises.
Any ideas? Seems to be the opposite of what engine temp should be.