Case Edging Source?

[thegisguy]

I have a quick question about moding my Antec 900.

As I've mentioned in another post I have been cutting up my MB tray to aid in cable management. Now I want to put some rubber edging on the hole to give it a more professional look.

My question is can anyone suggest a common local source? I have checked out Lowes, Home Depot, Ace Hardware, and Auto Zone.

I'm looking for something like this, but hate to pay $$$ for shipping, and don't really want to wait either...

Update: I found exactly what I was looking for at Pepboys

 

[Zepper]

Try your local sheet metal and/or metal fabrication shops.

.bh.

 

[Tullphan]

You might also try contacting Jim @ CoolCases.com...he uses something similar when he modifies his case.
He's reasonable & isn't out of line on shipping.

 

[WoodButcher]

Small rubber or vinyl tubing, cut a slice lengthwise, The tubing used for windsheild wipers.
I bought some of that edging from Frozen PC and was very unhappy. It has small cuts every 1/4" or so to make the radius. Not pretty.

 

[Rubycon]

Norprene A-60-G like this stuff here.

I was given a roll and tried it and it works well. Controls sharp edges too!

 

[thegisguy]

Thanks Rubycon & Woodbutcher. I think I'll head to my local auto parts store to see if they have any tubing. I tried striping a wire last night and using the insulated rubber. Looked like crap and was a devil to get into place.

 

[wwswimming]

some autoparts stores sells a roll of u-shaped plastic for putting on
the edge of a door on a car. for metal about .070 thick (but will
take a range of thicknesses.)