Car enthusiasts

ScottyB

Diamond Member
Jan 28, 2002
6,677
1
0
How hard is it to build a car? My dad and I both have wanted a jeep for a while and I thought I could save up so we could start putting one together on weekends and stuff. I don't know anything about cars :D but my dad knows quit a bit. I was thinking that if I saved up a grand we could slap something together. What do you think? I also thought this might be a good bonding exp. since we have grown apart the last few years.
 

Zenmervolt

Elite member
Oct 22, 2000
24,514
44
91
If you're thinking of a "project" car, I'll give you one very important piece of advice: do _not_ buy anything that has even the slightest bit of rust or body damage. Bodywork is the single biggest bitch I've seen when working on a car, and rust repair is the mother of all expense when working on a project. Last year I bought a 1976 914 that is quite clean for about $3,500 as a "rolling restoration" project. It runs fine right now but it needs a lot of work to be brought back to showroom. I could fix all the mechanical problems for under $2,000. $2,000 wouldn't even begin to cover the minimal bodywork that needs to be done. The paint is shot and it needs a re-spray which will probably run me around $5,000 because the only way to do a re-spray properly is to have everything acid-dipped and then get each part painted separately. Properly re-painting a car pretty much requires that the car be disassembled. (That's not to mention the new rear floorpan and the fender repairs that need to be done.)

Find something with a good body but a blown up engine and tranny, much less trouble and expense in the long run.

ZV
 

Stallion

Diamond Member
May 4, 2000
3,657
0
76
I have a Jeep, it just cost 2,000 for front discs, hubs,spindles,axle u-joints and ball joints. So like Frustrated said.. 1,000 will get you squat.

3,500 is a little safer bet. Jeeps are spendy even for junk ones. You are talking Jeeps and not wranglers right?
 

ScottyB

Diamond Member
Jan 28, 2002
6,677
1
0
I have a Jeep, it just cost 2,000 for front discs, hubs,spindles,axle u-joints and ball joints. So like Frustrated said.. 1,000 will get you squat.

3,500 is a little safer bet. Jeeps are spendy even for junk ones. You are talking Jeeps and not wranglers right?

Like a CJ7 or something
 

Stallion

Diamond Member
May 4, 2000
3,657
0
76
1974 CJ-5 304 V8, 3 speed T-15 trans, dana 20 transfer, dana 44 rear and dana 30 front. ;)