Can't get 566 celoron II to boot at 850

[kaboom91]

I have an Abit BE6-II revision 1 with the latest bios update and softmenu III, I have abit slocket III, and a Celoron 566, and a Guillemot 3d Prophet DDR-DVI geforce vid card. I changed the bus speed to 100mhz and upped the core votage in softmenu to different settings with no succes. My slocket volt and bus setting are set to auto which means I only have up to 1.75 available in the bios. when i change the bus to 100 no matter what i try i can't seem to get a video signal to the monitor, At higher core volts I might get a vid signal briefly but it doesn't get anywhere near windows. What am i doing wrong?

 

[Ulysses]

You may have just been unlucky enough to get a chip that can't take the higher bus speed. There are no guarantees in o'clocking. Try other FSB's above and below 100.

See:
http:// [url]http://www.giga-byte.com/gigabyte-web/faq_gt.htm [/url]

http:// http://www.overclockers.com/

 

[compuwiz1]

Hey, this looks like a conversation I just had on icq with somebody.

 

[Coki]

Clear CMOS. Do the voltage on the converter board. You might need like 1.9 volts to get the celeron stable.

 

[Coki]

Clear CMOS. Do the voltage on the converter board. You might need like 1.9 volts to get the celeron stable. Only do the voltage in the slotket everything else like BUS speed do in the BIOS.