Can someone with an NF7-S....

[Nickc19]

...post a picture of the I/O plate on the back? I dont know if i'm retarded or what, but one of the little metal tabs that stick out in the back around the openings isnt letting me fit mine on correctly. Are you supposed to pull any of the tabs out/off?

-Nick-

 

[Banana]

I'll go look at my NF7S if you identify which hole.

 

[Nickc19]

Originally posted by: 1YellowPeril
I'll go look at my NF7S if you identify which hole.

Crap, I'm at work right now so I cant look right now. If you were looking at the front of the plate, so where the long sides were on the top and bottom, I *believe* its the opening on the far left.

-Nick-

 

[Nickc19]

(dp)

 

[gistech1978]

why cant you just bend them back.
i have an NF-7s @ home.
im @ work.

 

[Nickc19]

I'm sure I could....I just wasnt sure if you were supposed to bend them back.

-Nick-

 

[foofoo]

how big of a close up do you need?
here's a picture of the backplate

here
good luck

 

[Sonic587]

Just bend them back...break them off, ect. An I/O plate isn't going to affect your sytem.

 

[simms]

Originally posted by: Sonic587
Just bend them back...break them off, ect. An I/O plate isn't going to affect your sytem.

I was dumb enough to pay like $10 to get one.

 

[LED]

Nickc19...if you still need 1 backplate then PM and I'll hook you up for shipping only but next time post your request in th Motherboard Forum

 

[Lonyo]

Good choice of mobo though (waiting on my second one for second computer Should arrive today. Abit all the way)

 

[LED]

Originally posted by: Lonyo
Good choice of mobo though (waiting on my second one for second computer Should arrive today. Abit all the way)

Why I quit Abit (ala DFI isn't much better) is cause of there give me money up front RMA service + their 939 and in the beginning Nforce ...here Consumer buy policy looks the same

 

[Jiggz]

The tabs on the back were designed to sit on top of the connector to maintain ground continuity when you plug into it. I'll saypull them back to clear them and then release them as soon as you get the mobo situated.

 

[Nickc19]

Thanks guys....I got this sorted out soon after I posted this...there was one tab I finally just pulled off to get the mobo in place right, other than that, no problems.

-Nick-