++ ATOT official NEF thread part IV ++

Page 4585 - Seeking answers? Join the AnandTech community: where nearly half-a-million members share solutions and discuss the latest tech.
Toggle sidebar Toggle sidebar
MongGrel

MongGrel

Lifer
Dec 3, 2013
38,466
3,067
121
It's still a nice new one, I don't want to hit it with a stick.

Toolmakers would usually get out a big ball peen and hit shit like that though.

More true to life :p

That or a big Dead Blow, if your new wave.

Still hot dammit.
 
Last edited:
Red Squirrel

Red Squirrel

No Lifer
May 24, 2003
70,767
13,863
126
www.anyf.ca
Being in Florida with no AC is probably as bad as being here with no heat.

My furnace started acting up a couple months ago. The pressure switch would get stuck open, so once the furnace finished it's cycle it would not start again after. Thankfully it was an easy part to get and to change. Literally one screw, and two tubes to connect.
 
Red Squirrel

Red Squirrel

No Lifer
May 24, 2003
70,767
13,863
126
www.anyf.ca
Being in Florida with no AC is probably as bad as being here with no heat.

My furnace started acting up a couple months ago. The pressure switch would get stuck open, so once the furnace finished it's cycle it would not start again after. Thankfully it was an easy part to get and to change. Literally one screw, and two tubes to connect.
 
MongGrel

MongGrel

Lifer
Dec 3, 2013
38,466
3,067
121
Air back on, I learned a bit about secondary sensors on the new HVAC systems in the process.

Apparently there are more than one that I was aware of that can shut one down obviously.
 
You must log in or register to reply here.

TRENDING THREADS

COMPANY
RESOURCES
FOLLOW
Top Bottom