++ ATOT official NEF thread part IV ++

[Barfo]

75626

 

[rudeguy]

and then it somehow devolved into this:

https://www.youtube.com/watch?v=inyIe1KQYdk

 

[Barfo]

75627

 

[rudeguy]

I've been taking some measurements today and if I clench my butt cheeks really tight, I sit 2 inches taller in my chair.

 

[SaDiZTiKStyLeZ]

http://www.youtube.com/user/Just4TheFunkOfIt

 

[fjmeat]

I've been taking some measurements today and if I clench my butt cheeks really tight, I sit 2 inches taller in my chair.

omg what!

 

[SaDiZTiKStyLeZ]

I've been taking some measurements today and if I clench my butt cheeks really tight, I sit 2 inches taller in my chair.

It will only hurt more when you clench your butt cheeks. Relax & loosen up a little.

 

[mnewsham]

Nef

 

[Barfo]

 

[Barfo]

 

[Barfo]

 

[Barfo]

75637

 

[Barfo]

75638

 

[Barfo]

75639

 

[Barfo]

75640

 

[Barfo]

75641

 

[fjmeat]

 

[fjmeat]

monday afternoon neff

 

[rudeguy]

keggles my friend...keggles

 

[fjmeat]

what are you working on right now neff?

me: building a quickbooks file + neff

 

[rudeguy]

what are you working on right now neff?

me: building a quickbooks file + neff

Fixing terminals

I had one with a tamper error which is pretty ease. Just need to desolder the old internal battery, solder in a new one and run the software. However someone had done a half assed job and only soldered it halfway though, then soldered the rest with a huge solder ball. I got off what solder I could and tried to get the battery in but couldn't. I heated it in the preheat station for 30 minutes like I normally do on stuck ones. Unfortunately I forgot that I was testing with it on Friday and left it set to 400 C. When I pull it off the preheat station, 2 IC's and a connector fell off. Somehow I even managed to melt the pads off the connector. I don't have the stuff to fix pads right now, so I had to pitch it.

Killed a $250 machine because my dumb ass didn't look at what temp the IR station was set to.

 

[sdifox]

Meeting nef

 

[fjmeat]

Fixing terminals

I had one with a tamper error which is pretty ease. Just need to desolder the old internal battery, solder in a new one and run the software. However someone had done a half assed job and only soldered it halfway though, then soldered the rest with a huge solder ball. I got off what solder I could and tried to get the battery in but couldn't. I heated it in the preheat station for 30 minutes like I normally do on stuck ones. Unfortunately I forgot that I was testing with it on Friday and left it set to 400 C. When I pull it off the preheat station, 2 IC's and a connector fell off. Somehow I even managed to melt the pads off the connector. I don't have the stuff to fix pads right now, so I had to pitch it.

Killed a $250 machine because my dumb ass didn't look at what temp the IR station was set to.

woops - are these new items ur building?

 

[fjmeat]

Meeting nef

about what neff

 

[rudeguy]

woops - are these new items ur building?

no

I fix them. So technically it was already broke when I got it. Now its just more broke.