++ ATOT official NEF thread part IV ++

Page 6753 - Seeking answers? Join the AnandTech community: where nearly half-a-million members share solutions and discuss the latest tech.

Red Squirrel

No Lifer
May 24, 2003
70,540
13,791
126
www.anyf.ca
Ran out of siding. One single piece, literally is all I needed to finish. Went to HD to get it right before closing, then got texted by a friend to hang out so I went to hang out. Hanged out till around 10 and it was starting to get dark so decided to call it quits for the night. Did some decent progress today though. There's only a small section left to do, the I can start on the ramp, then it will more or less be done. Will build some shelving inside and pretty much call it done. Oh and need to look at solar panels, might put a couple 100w worth of solar on the roof and get a MPPT charge controller.
 

sdifox

No Lifer
Sep 30, 2005
100,173
17,880
126
Ran out of siding. One single piece, literally is all I needed to finish. Went to HD to get it right before closing, then got texted by a friend to hang out so I went to hang out. Hanged out till around 10 and it was starting to get dark so decided to call it quits for the night. Did some decent progress today though. There's only a small section left to do, the I can start on the ramp, then it will more or less be done. Will build some shelving inside and pretty much call it done. Oh and need to look at solar panels, might put a couple 100w worth of solar on the roof and get a MPPT charge controller.


Take it from the left side and put it on the right side. Done.
 

Red Squirrel

No Lifer
May 24, 2003
70,540
13,791
126
www.anyf.ca
Take it from the left side and put it on the right side. Done.

I had like a 3 feet worth left over. Can't make it longer no matter how hard I try. :p

Though interestingly I'd say a huge chunk of the job does not have any seams, just the way things ended up. Hardly any waste either. The long sides used a full length minus like 1cm so I have a bunch of ends that are like 1cm. Have a bunch of triangular cuts from the roof peak and couple 1 foot sections and that's pretty much it as far as waste. The waste generated from the back side was actually a perfect fit for the door side if I cut it in half for both sides of the door. Total fluke there.
 

zzuupp

Lifer
Jul 6, 2008
14,866
2,319
126
image1397302x.jpg
 

zzuupp

Lifer
Jul 6, 2008
14,866
2,319
126
I'm not a real hockey fan. It was good to see the homers FINALLY win. ( and not lose to the Penguins the 1st or 2nd round )
cut.jpeg