• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

ata-100 on kt7-raid

I

infiniD

Member
I was trying to put a single IBM 75gxp into the ide3 connector on the kt7 (so that I could take advantage of the 100 mb/s) but it would not find the drive upon boot... is this because I must have the drives raided or is there a setting I must adjust in the bios?

thanks..
 
I don't have my KT7-RAID yet, but as far as I understand,
you have to change the boot order in the CMOS to point the the
highpoint controller first; for any devices that are booting
from IDE3 or 4.

 
I just got my KT-7 Raid up and running with one Maxtor ATA100 drive. I just plugged it into the ATA100 bus, set the boot partition from the highpoint controller (by hitting Ctrl-H when prompted to do so), and then set the primary boot device to be the ATA100 in the bios.

HTH and good luck.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top