Any Liquid Cooler fits Lian Li PC V354?

[pectin232]

Anyone tried to fit any coooler with this board : GIGABYTE GA-Z68MX-UD2H-B3 LGA 1155 Intel Z68 HDMI SATA 6Gb/s USB 3.0 Micro ATX Intel Motherboard and the Lian Li PC V 354? Thanks. The H60 does not fit.

 

[ShadowVVL]

I think it would fit up in the top fan port. unless you tried that too.

 

[Claudius-07]

I currently have the Li PC V 354 (silver). I have the H70 installed. I had to hack the case to fit it. The rad plus two fans is in the front of the case. Essentially to get it to fit I had to remove the internal metal structure that holds normally the optical drive on top and hardrive bays. Once that is removed, it will fit on the 2nd intake fan in the front. The bottom fan fits under it. There will be no room for an optical so the open slot in the top front of the case is useless. That was the only way I found to place that kit in there. Works actually quite well. I never tried any other cooling solutions. I just have 2 SSD drives in there, so I just placed them on the base of the case... I did not care really where they went... It does not look pretty but who cares, the case is closed.
I have the GiGa H55n-USB3 mobo in there so not the same as yours. But the issue again was not the board.

 

[aigomorla]

ummm u can custom one..

it wont be cheap... but its possible to fit internally.,

 

[pectin232]

Hi Claude I was very serious about doing it... but decided not to.. I have the H55n as well on a smaller case. I am wondering what Cooler can really fit into this.. liquid ones..if possible or if Air it might get noisy... ideas anyone? I have the GA-Z68MX-UD2H-B3 LGA 1155 Intel Z68 only...

 

[fx_rage]

You can fit full liquid cooling set ups in a v351, which I believe is smaller than the v354, but can fit mitx boards. I just built a rig with a v351 and managed to fit 2 240 mm rads in the case, required a lot of hacking though, but it can be done. If you want just one you wouldn't have to cut it at all.

There are all in one kits that do very well, I based my build on the XSPC Rasa 750 kit. I highly recommend it.

 

[pectin232]

what about this: XIGMATEK LOKI SD963.. will it fit or COOLER MASTER Hyper N 520 or Noctua NH-C12P SE14.. I am thinking if it is too tall. If Liquid cool does not work then maybe Air is the best bet for now..