Annihilator 2 and ABIT BE6-II

[trance]

I have my P3-700e running at 900mzh just fine but my system bus is running at 129mzh. Would there be a problem with the Annihilator 2 not working at this high bus speed? Thanks.

Note: Everything in my system is working fine with the high FSB including my AGP TNT1 and V2.

I am also considering to buy from Z-buy.com for $ 265.50 (grand total including shipping).

 

[Spook]

I can't get my GF2 to like FSB's above 124Mhz.... I have a Hercules Prophet 2 GTS 64Meg...

 

[BuddyHolly]

My GF2 is good to 130fsb until the limits of the CPU kick in. I have a new peltier that may push it a little higher..

 

[rayon]

I have the same Annihilator2, BE6-II and P3-700E, but mine is running @1001MHz (143MHz FSB) and everything is working just fine. According to an article from Anand (http://anandtech.com/showdoc.html?i=1270&p=7), the Annihilator2 should run fine up to 148MHz FSB.

 

[qmac]

I have the same system. can you list all your bios settings, if you don't mind? agp and pci multiplier and such. thanks

 

[rayon]

I'm not close to it right now, but I can list some of the settings I remember. If there is any specific one you'd like me to list here, let me know:

P3-700E @1001MHz, 1.85v, retail heatsink/fan from Intel,
SSpec SL45Y from Malay
FSB: 143MHz
AGP divider: 2/3
PCI divider: 1/4
AGP Mode: Default
Queue deep: 8

I'm using some 128MB PC133 CAS2 from MemoryMan and all my memory settings (CAS, RAS, etc) are set to 2.

Hope that helps,

 

[trance]

Thanks for the reponses, I will now order the card from Z-buy.com. Its been years since i upgraded to a new video card (tnt1 and v2). I am expecting a HUGH IMPROVEMENT!

 

[trance]

Just ordered it from Z-buy.com. 🙂 🙂