AN35N-Ultra question...

[cmdavid]

I just bought an AN35N Ultra mobo and am having some problems with it....
I see that it says it is compatible for DDR speeds up to PC3200, but i have PC3700 RAM.. shouldn't this ram work properly, but only at 3200 speeds?
also, it is a dual ram kit, so is it proper to put the RAM in DDR slots 1 & 3, rather than 1&2?
I am running it with a 2400+...
I plugged everything in and had no post or anything, so i was wondering if there could be any other problems...
ive got the same ram/processor running on a K7S5A just fine, but when i put them in the AN35N, it doesnt work... any suggestions? i tried clearing the CMOS and all that good stuff, but no luck...
thanks..

 

[cmdavid]

bump, somebody has to be able to help me...

 

[DAPUNISHER]

For dual channel with 2 sticks you use slots 1&3 or 2&3, but for purposes of trying to get the system to boot start with 1 stick and try it in slot 1 then slot 2 if need be. Do you have both the ATX and 4pin 12v power connectors attached? If so, what power supply are you using?