Ahhh i'm an idiot!

[n7]

I need some guidance 🙁

I have a TT SilentPure 480W PSU in my second rig.

A few minutes ago, i was attempting to reorganize the messy wires/cables inside the case, & in the process, i snapped the PSU fan controller cable in half (allows me to set what speeds the PSU fan runs at).

Will i fry something if i try turning it on with the wires not connected to anything?

There are now two little exposed wires...damnit i dunno what to do.

Any ideas would be appreciated.

 

[keeleysam]

just short those two wires.

 

[twitchee2]

try and match the ends up. then solder them that waht i would do

 

[n7]

Originally posted by: keeleysam
just short those two wires.

I'm completely electrically challenged...how do i do that?

I don't care if the fan controller works or not, i just want to be able to safely run things.

 

[eXx08]

just cut them really short if you cant meet the ends together. Out electrical tape on the ends.

 

[Cheezeit]

How did you *snap* a cable in half?

to short the two wires, twist them together

 

[n7]

Originally posted by: Cheezeit
How did you *snap* a cable in half?

to short the two wires, twist them together

I'm not actually sure. I was trying to sorta fold them in a corner out of the way...bad bad idea.

Thanx guys.

I will try twisting them together, but it's gonna be hard, since they are tiny.

 

[Cheezeit]

Good luck, n7

 

[n7]

Thanx so much guys...now i just have to go buy some electrical tape.