A8N-SLI Deluxe and NVIDIA nTune

[GodLovesPunk12345]

When I start up nTune, it gives me a warning saying "Your PCI clock is currently set to track the HT bus. If you adjust the clock for the HT bus, the PCI bus clock will change as well. Please consult your motherboard manual to determine how to disable this behavior before proceeding." So, how do I disable it? Thanks

 

[GuitarDaddy]

Set HTT to 201 or higher in bios

 

[Insomniak]

Or, flash to a new BIOS and enable the lock.

 

[disruptorsignals]

I flashed the new bios 1003.006 and am having problems with ntune still it almost it gets to adjusting htt bus then comp restarts and asks if I want to restart cause failed.

 

[disruptorsignals]

I also did the 33.3 mhz pci bus lock in bios.

 

[dababus]

Originally posted by: disruptorsignals
I also did the 33.3 mhz pci bus lock in bios.

I am encountering the same problem.

ntune reports pci bus at 19, clock gen increases pci bus if I increase htt. I am using 1003-008 bios with 33.33 mhz pci lock enabled and still it doesn't seemed to be locked.

 

[Regulator07]

lock the pci to 33.33 and put the HTT to 201, that fixed it for me

 

[finbarqs]

How do you put the HTT to 201? I only see the HTT as 1x, 2x, 3x, 4x, 5x, Auto

 

[Regulator07]

Originally posted by: finbarqs
How do you put the HTT to 201? I only see the HTT as 1x, 2x, 3x, 4x, 5x, Auto

no no, the HT or hypertransport is set to 5x, the HTT or FSB needs to be set to 201, sorry HTT and FSB are the same thing

 

[finbarqs]

heh, yeah figures.. :\... my HTT is at 240, mult is 11.. 2640... NOT stable... ram at 3-4-4-10 HT at 4x.... 2 instances of P95 crashes in 5 minutes.

 

[Regulator07]

Originally posted by: finbarqs
heh, yeah figures.. :\... my HTT is at 240, mult is 11.. 2640... NOT stable... ram at 3-4-4-10 HT at 4x.... 2 instances of P95 crashes in 5 minutes.

yeah i havent done much overclocking yet, havent had the time, but did manage to figure out that HTT 201 problem, i still think it is a bios problem, because with auto voltage on 200 the cpu is underpowered and at 201 on auto it is perfect, or at 200 with uped voltage but that just puts you at the same place. hopefully that will get corrected in a new bios, unless it is a hardware problem. well it works for now anyway.

you may want to bring down the multiplier on that overclock, just a suggestion, i cant say from experience though..yet!