667@750 stable(:Owow i know) should i try to take it higher?

[spaceman]

well i bumped the fsb up to 75mhz on my celeron 667,rebooted posted @750mhz and ran stable for a couple hours,hehe then i got nervous and set it back to default.This was @ 1.75v.I dont think the 80mhz is quite enough of a jump in speed,my bios only has the opton to run @ default/66/or 75mhz on my biostar however i can set the jumpers insde to run @ 100mhz fsb.Should i give it a shot?I fairly new to ocing,and dont want to fry the chip,it handled the 75mhz fsb very well afaik but 100mhz im a little intimidated by.Unfortunately i dont think there are any other fsb settings aside from 66/75/100/133 on this board.Any advice would be appreciated.

 

[arod324]

A 100mhz FSB would be hard with your chip, since it would give you 1.0 ghz, which is about the limit of the CeleronII chips. If you had a 566,600, or 633, it would probably be easier to hit 100mhz FSB.