- Jan 28, 2003
- 2,254
- 1
- 0
I just bought a new enermax case with room for 4 80mm fans and one 120,it has an 80mm blow hole two rear and one side and a 120mm in the front. It came with a fan blowing into the case already installed in the side and i had one from my old case which i put blowing out through the blow hole (This cause about a 5-10 degree drop in temp from my old case) . I then bought a new 80mm fan and installed that blowing out of the back and my temerature went up!. I thought this was maybe because of orientation so i turned it round to blow into the case that again raised my temperature. Does anyone know why this is? Where would i be better putting this fan and blowing which way? i dont think i really need it as my temps are 47/32 after running seti for 48 hours non stop on a warm day but seen as i have it i may aswell put it to use. Any ideas? Thanks
