Recent content by luckyluca

what model is your orico enclosure? I would like to get an asm2362 but it's hard to figure it out from the seller's websites. What's the autosleep? I was going to get the 20gbps just for future proofing since one of my computers already support it, but I don't know if 20gbps requires more power...

Thanks. https://amzn.eu/d/bVeKNvE Vention rtl9210B-CG enclosure with latest firmware. I’m thinking of getting this 20gbps enclosure rtl9220 for the wd nvme, it’ll run at 10gbps on my current pc. It’s not going to draw more power than the 9210 version is it? https://amzn.eu/d/c4ncHXE

I have a western Digital nvme 4tb and I may have damaged it. I was copying a lot of files to test a cheap 9210B-CG enclosure. When I stopped the copy and the nvme went idle, temp showed that it started raising up gradually until it reached 90C (!!!) so I unplugged it straight away. I won't be...

Ok thanks, i’m glad they’re similar. I’m going with the 9220 and setting sleep low then.

Thank you. I'm looking at a new rtl9220 enclosure as well, running at 10gbps for now, with the idea of using it with a 20gbps compatible laptop in a few months. I have already found the firmware for it. If it runs at 10gbps on my current 10gbp PC usb port, does it produce less heat, roughly...

Awesome, thank you! And if I wanted 5 minutes, would that be 'DISK_IPS_THRES = 0x05'? Please note that the config currently says ';DISK_IPS_THRES = 10' On the chipset of this Orico enclosure, it physically says RTL9210 (non-B): https://orico.cc/index/product/detail/2938.html I'm confused...

Many thanks, I flashed the latest FW to my orico RTL9210 enclosure and it seems to have fixed this disconnection issue. Is there a way to specify the sleep timeout in minutes in the configuration file? I'm asking because it appears like my enclosure is not going to sleep after 10minutes anymore.