Recent content by BigDogChief

no....PastorDan suggested using my other PS....That PS runs my old computer...it sure wouldn't run the new system...

Anybody ever had the MOB make a high pitch noise (sort of like letting air out of a ballon by pinching the air valve) when you first plug your system in? This is in reference to the topic I posted about not being able to power up my system. At first I thought it might have been the power...

Anybody ever had the MOB make a high pitch noise (sort of like letting air out of a ballon by pinching the air valve) when you first plug your system in? This is in reference to the topic I posted about not being able to power up my system. At first I thought it might have been the power...

Ok, all I had hooked up was the PS, the power switch feeder, and the RAM; turned it on, and it started to go, but then stopped (like it has been doing). I tried to power switch button, and it tried to turn on (finally got the power switch hook up right) it started up, and shut right back down...

Ok, all I had hooked up was the PS, the power switch feeder, and the RAM; turned it on, and it started to go, but then stopped (like it has been doing). I tried to power switch button, and it tried to turn on (finally got the power switch hook up right) it started up, and shut right back down...

Thanks folks! I promise to stop lying! :) I'm going to give a new power supply a try....

Well Dan, the old power supply is only 110 watts. (The CPU is only a AMD-K6 400MHZ). Don't think that would do it. Also....(Here is a post that I put on another group) I have flipped the Power Switch Connector around. On the ECS K7VTA3 they have the Panel Connector, but also have a LPANEL...

I have flipped the Power Switch Connector around. On the ECS K7VTA3 they have the Panel Connector, but also have a LPANEL Connector (For OEM use). The thing is that for the Power Led Connector you have to connect it to the LPANEL, but for the rest (Power Switch, Reset Switch, HDD LED) they...

What type of MOB did you have? Did you just switch the polarity? Or was it more than that??

I sure wish I knew where the grounding problem would be. Very frustrating, especially since Newegg makes you pay for the returned item....

No. It tries, but it stops due to the fact that the PS no longer is on.....

I lied again, the PS fan does turn on, for about 3-4 secs then shuts off, leaving everything else dead, except for the red light on the MOB. Nothing else works, can't open the CD-Rom, nothing. It's like it has enough juice to get started, but then dies. It does the same thing every time....

MOB: ECS-K7VTA3 Memory: 256 MB DDR - PC2100 Crucial IBM 40 GB 7200 RPM HD Sound Blaster Live 5.1 KYRO II 64 MB Video Card When I plug the computer in, the fan starts to go, then dies. However, the MOB says there is power to it. I would think that the CD-Rom would at least open and close...

Yes, the memory is in.....

Has anybody ever had problems with the included enlight power supply that comes with this case? I am putting together a system with this case and cannot get the thing to startup. The PS will start to get going, and then it dies. Any suggestions?