XP1600 as high as 59c @ idle-too hot? What's an acceptable temp range at idle/load?

[linux247]

I've read that this cpu's temp can go as high as 90c (max) before it fries. What temp range should I be looking for and can you trust the mb temp sensor? I'd like to hear what other peoples experience has been with this cpu.

 

[FluxCap]

From my constant temp checking and tweaking in the past month I can say yes that is a little high. What motherboard are you using?

 

[linux247]

It's a MSI mb. At what temp should I start being concerned? Last check it was at 56c with side cover off. BTW, what utility do you use to monitor cpu temps (if any) - I am periodically rebooting and going into the bios to check mine.

 

[FluxCap]

I am basing this on what people say around these boards and around 60 or higher is kinda high and this is before you O'Clock. 56 sounds better and that makes me think your case doesn't have many fans or any for air flow? correct?

I use the Abit NF7-S and look at the hardware doctor that comes with my MB drivers for checking temps.

 

[linux247]

Thanks for the reply FluxCap. The temp has now dropped to 55c (mostly idle) after being on for about 4-1/2 hours now with the case closed - hmmm. The case is an Antec w/ an Antec PS, but does not have any additional fans. Do these things have a break in period or something???

Edit: System temp is hovering between 49c to 50c - nVidia card seems to be pretty hot. Anyone know where the sensor is located on most boards that monitor system temps?

 

[FluxCap]

I wouldn't think there is a break-in period but I could be wrong.

 

[EdipisReks]

put some fans in the case, for the love of all that is good!

 

[AtomicDude512]

Originally posted by: EdipisReks
put some fans in the case, for the love of all that is good!

I agree.

 

[linux247]

Originally posted by: FluxCap
I am basing this on what people say around these boards and around 60 or higher is kinda high and this is before you O'Clock. 56 sounds better...

Ok, if '60 or higher kinda high' then what is an ideal (or reasonable) temp range for the XP1600? I plan on adding fans, btw.

 

[EdipisReks]

idle at 35, maybe? load at 50 should be obtainable with decent cooling.

 

[DKNYSprt95]

Originally posted by: EdipisReks
put some fans in the case, for the love of all that is good!

Good, but it seems that a good heatsink and proper thermal paste installation works 10x better than having 5 fans... I have 2 systems and this is exactly the case. Just buy a SK6 for about $20 and a quiet 60mm fan, you should see temps in the 30 range.

 

[blakeatwork]

1) Check mounting of HS/F to make sure it's aligned correctly and flush with the core...
2) Add an exhaust fan, 2 if ya can to draw air across your board
3) An intake fan is a secondary reuirement to #2
4) If you're using thermal grease, check to make sure your coating is thin enough.. I had a nearly opaque coating on my XP 1900+, and when I removed the heatsink to redo it, I used less, and had my temps drop by 3 degrees...